And frankly I cannot disagree with you, its beyond tedious for some things I had for muscle memory on fusion, its really up to your cost to benefit. My largest necessity was to be able to handle assemblies with parametric parts, and do it without subscriptions or royalties/licensing agreements. Blender maybe could work in a pinch, but I need my designs to be constrained.

All that said, the improvement to freecad 1.0 made me blind to a lot of its quirks, because it was such an improvement for me. I tried so long with early freecad and wound back to fusion again and again. That it was finally useable is what called me over… but that is not the best advertisement, is it? Lol

FreeCAD! I dont mean to be a evangelist, but it is finally good enough for myself that I made the leap from Fusion, and I haven’t missed it a moment. Your mileage may vary, but now is better than ever to give it a(nother) try

Ubiquitous and Tiamat are my servers, Polyglotal for my home assistant voice endpoint, and some more. Points for the reference

Did you know: all language is fake and made up?

Just dont try to spray up your ass, its pretty hard but you dont wanna.

But now you only use three or four squares of TP to dry off instead of fingerpainting shit all up your asscrack until the point you’ve been conditioned to believe is clean enough.

One problem though, shitting at your workplace or anywhere else will be insufferable. My LPT is to take one of the better hand towels and wet it in a sink before hitting up a stall. Thank me later.

2027 Bingo Card: US adopts BTC as reserve currency, replaces USD, both crash.

Honestly, no arguement here. I can’t think of anything better so I’m unqualified regardless

There is Friendica… yeah the name doesn’t roll of the tongue, and I only remember just for this comment… no shade to it

Someone mind explaining this shit? It’s about the 5th time I’ve seen this spam, whats the goal?

Where’s RedstarOS?