Nice! Mine is probably around 8 years old now. I had one section pull apart like you were saying, so maybe not user error. I ended up pulling up that section, replacing any price that seemed suspect, and glued the joints during reinstallation. That’s actually what drove me to replace all the old T mold thresholds. But yeah, just that one defect across 900SqFt (84 SqM) isn’t bad.

That’s a good idea, thanks!

That is brilliant!

Sure is! I got it from a local flooring store and installed it myself years ago. It’s hard to beat the price and hardness.

That was my issue too! With the floor’s expansion gap, it needed to cover about 2-2.5 inches in width. Everything in that range was more for industrial or exterior use. The S4S oak plank I used was $16, with pre-made thresholds being $25+. Of course, tooling is a limitation. You’d at least need access to a router to make this.

I picked up a piece of hardwood that was 5/8 inch thick. Just measure the gap under your door so you know how tall the threshold can be. I went with a 3.5 inch width to cover the floor’s expansion gap with room to spare. I just cut that down to the width of the door. Then I used a router to put a 45 degree chamfer on all 4 sides.

The 45 degree angle goes down about half way, I just ran a scrap piece through the router and progressively raised the bit until the angle felt right, then did it on the final one.

Gave it a light sanding to remove any splinters and then I just stained it to match the floor and used a rubber mallet to get it in place. It’s pressure fit, so it’s a little tight to hold it in place. Some people opt to screw them into the floor below instead.

Thank you Friend!