I wrote my own fillet function in openscad. It was a fun adventure to work out the geometry. Next time I’ll use some else’s function.
I wrote my own fillet function in openscad. It was a fun adventure to work out the geometry. Next time I’ll use some else’s function.
Like mDNS?
The blue sponges that ate for non stick are softer than the normal green ones. The rough side of the blue ones are safe for non stick assuming your aren’t giving it everything you’ve got.
These ones:
It’s less than before the first GN rant. IMO It’s much more relaxed and thoroughly written now. IMO The ECC Squad effort is actually working. IMO It’s still mostly dumb, bleeding edge, junk food content; but it’s easier to watch now than before.
It’s not your cup of tea, fine. Then don’t watch.
Proxmox can be a bit of a bear to setup. The documentation is not very approachable for new users. It uses a lot of terms without definition which is a deadly sin of technical writing IMO. Guides for getting an Ubuntu Server VM setup vary wildly and often recommend outdated settings.
I’m totally on board with using it though. It eliminates the need to start from scratch when migrating to newer hardware.
Set up your favorite Linux server distro and then go ham on setting up docker (dockge is a great tool to introduce compose).
Woah there! This is GNOME. You don’t get choices.