Created a new replacement dust adapter for my circular saw that replaces the original one. The original didn’t fit my Nilfisk Multi II 30 shop vac. Now I don’t need to fiddle with the adapter I first made.

Sharing if someone has the same combination: https://makerworld.com/en/models/996710

  • Thorry84@feddit.nlEnglish
    5·
    4 days ago

    Let us know how you get on!

    I tried the 45 degrees method, but my print bed wasn’t quite large enough to make it fit. It ended up too short and the hose kept falling out.

    • Prizephitah@feddit.nuOPEnglish
      2·
      18 hours ago

      It has held up fine! Super sturdy and not a single doubt in my mind that it will last as long or longer as the original. I can put real heavy loads on it without any issues. I don’t think the layers are a problem in this application.

    • Prizephitah@feddit.nuOPEnglish
      3·
      4 days ago

      Will do! Planning to put some OSB boards up this weekend. Should be a fair test by going through a stack of ten boards.