Created a new replacement dust adapter for my circular saw that replaces the original one. The original didn’t fit my Nilfisk Multi II 30 shop vac. Now I don’t need to fiddle with the adapter I first made.

Sharing if someone has the same combination: https://makerworld.com/en/models/996710

  • Prizephitah@feddit.nuOPEnglish
    5·
    4 days ago

    Printed the same as you, a standing tube. I used PETG for the best layer adhesion. The walls are 3 mm thick solid. It has held up fine so far, but i haven’t had the opportunity to put heavy use on it yet.

    I actually thought about it before printing it and my backup plan is to print it at 45 degrees angle with more supports if it doesn’t hold up.

    • Thorry84@feddit.nlEnglish
      5·
      4 days ago

      Let us know how you get on!

      I tried the 45 degrees method, but my print bed wasn’t quite large enough to make it fit. It ended up too short and the hose kept falling out.

      • Prizephitah@feddit.nuOPEnglish
        2·
        18 hours ago

        It has held up fine! Super sturdy and not a single doubt in my mind that it will last as long or longer as the original. I can put real heavy loads on it without any issues. I don’t think the layers are a problem in this application.

      • Prizephitah@feddit.nuOPEnglish
        3·
        4 days ago

        Will do! Planning to put some OSB boards up this weekend. Should be a fair test by going through a stack of ten boards.